![]() Installing TRAKTOR AUDIO 6 on Windows XP/Vista. Specifications Subject to Change.ĭisclaimer. 9.1 Readme / Knowledge Base / Technical Supportġ Welcome to TRAKTOR AUDIO 6!.8.4 Physically Re-configuring the TRAKTOR AUDIO 6.8.3.5 Disable USB Energy Saving Mode (Windows only).8.3.4 Recommended USB-ports (MacBook Only).7.2.4 Connecting CD Decks for DJing with Timecode CDs.7.2.3 Connecting Turntables for DJing with Timecode Vinyl.7.2.2 Setting Up TRAKTOR AUDIO 6 for External Mixing.7.2.1 Setting Up TRAKTOR AUDIO 6 for Internal Mixing.7.1.2 Connecting a CD Deck for Analog DJing.7.1.1 Connecting a Turntable for Analog DJing.7 Using the TRAKTOR AUDIO 6 (Setup Scenarios).6.2.1 Channel Setup (Port Configuration on Mac OS X).6.1.2 Channel Setup (Port Configuration on Windows).6.1 Advanced Configuration on Windows (Control Panel).4.3 Using the TRAKTOR AUDIO 6 with DJ Software.4.1 Selecting the TRAKTOR AUDIO 6 as Your System’s Default Audio Output Device. ![]() 3.2.3 Installing TRAKTOR AUDIO 6 on Mac OS X.3.2.2 Installing TRAKTOR AUDIO 6 on Windows XP/Vista. ![]() 3.2.1 Installing TRAKTOR AUDIO 6 on Windows 7.It is always in the red.Īny further suggestions would be greatly appreciated. I feel like i have tried everything to optimise my computer and to set up TSP2's latency settings etc but nothing seems to work. When i adjust different latency settings etc the pitch control on TSP2 software drops all the way down speeding my tune up to about 200 odd bpm which is weird. I am having popping, clipping and the pitch controls not stable (increases and decreases in speed, rendering it impossible to mix) I have tried various latency settings etc in traktor scratch pro but it always seems to clip, pop and operate badly. I have gone through and changed various settings on computer in order to gear it towards DJing and music production. I am running through a desktop computer, which i have checked and is more than powerful enough to run it. I have read what feels like everything i can find on the situation and tried everything. Just assumed because i was using turntables that was the go.Īlso the volume output on the Traktor Scratch Pro 2 software was set too high. Firstly i had it running through phono on external mixer. Have been tearing my hair out trying to make this run properly. If so what cartridges should i use?Īny advise would be hugely appreciated as i have run out of ideas. ![]() I have fairly cheap needles running, however they are in decent enough condition. The only thing i havent looked into is the quality of my needles. It gives the same clipping sound through headphones plugged into my external mixer (Numark DM1001X, so fairly old but works fine with direct vinyl). I have thoroughly cleaned the contact vinyl which are actually new. I don't have the specs of my computer on me but i have checked and double checked that my computer can handle it and all seems fine. Updated driver and firmware etc, gone through setup instructions multiple times, restarting computer, changing RCA leads, adjusting soundcard master volumes etc. It sounds like it is clipping really badly and the levels all seem really high (can't push faders up on mixer as its too loud). I have managed to get it running properly with the it calibrating correctly and playing through both channels, however. I have a Traktor Audio 6 unit and am trying to get it running with Traktor Scratch Pro 2, timecoded vinyl and decks. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |